Jerry-B-WI's latest activity

I think I finished up today. I reversed the bucket hoses and the bucket operates normally. I rerouted the pump hose so there is no...

I made some more progress today. On the way back from PT, I stopped at the little hydraulic shop. I got a pair of quick connects to...

Much cleaner setup with the new fittings. I'd be a little concerned with the weight/vibration on the 3/8 bolt setup. I can picture that...

Almost sounds like a plumbing project.

Just remember to measure twice and cut/weld once.

Why not just make an adapter to change direction of the handle? Square piece of stock with two holes drilled and tapped to the...

Can you get your tall elbows with the JIC swivels like the short elbows?

I would use a male pipe x female JIC swivel straight fitting. If you get a swivel fitting on the hose end it will have a o-ring in it...

Getting late tonight. I'll send some links tomorrow of the type of swivels I'd use.

If they used Loctite 242 it's only a medium strength. You can get them loose using hand tools. But you'll have to have the valve body...

This is a ORB, o-ring boss, fitting.

If you need new o-rings I'd go with the viton. As for the elbows I'd use ORB fittings, you can position them at any angle you need then...

Oops! I assumed the literature was from Kubota. It appears you are correct, if you have the hoses labeled correctly, the valve is...

Do you use the 3-pt? Figure 2 for the original valve shows A1-B1, A2-B2 then a pressure port and a tank port. Look at fig. 3 and it...

The first link doesn't work. But looking at the second link it looks like the power beyond is a pass through to another valve bank. I'll...